Ruptela - Customise Ignition Settings

There are instances where you could not connect vehicle ignition lines to our GPS device digital inputs or need different parameters to determine ignition status. In scenarios like this, you can make use of a feature called custom ignition parameter in Ruptela devices.

Follow below steps to configure custom ignition parameter

Step 1: Connect the device

Connect your Ruptela device to configurator

Step 2: Select the COM port

Select the COM port to which your device is connected.

Step 3: Click Connect

Step 4: Open custom ignition window

Choose Custom Engine and click the Customize button in the Data Collection section to open the Custom Ignition window.

Step 5: Select logical operator

Select logical operator for the engine detection conditions in the Logic selection section.

Step 6: Select the parameters

Select the parameters to be used. If Power supply voltage or/and GPS speed, RPM, Wheel based speed is selected, enter the threshold value(s).

Step 7: Enable the Switch OFF delay

If required, enable the Switch OFF delay in the Ignition state options section and set the period.

Step 8: Click IO events

Step 9: Select parameter slot

Step 10: Send I/O data

Opt “Send I/O data with v1.1 protocol”

Step 11: Select Custom Ignition parameter

Step 12: “Enable” IO properties

Step 13: Upload .cfg file

After selecting above parameters, you can upload the .cfg file to Ruptela device.